ArboristSite.com Sponsors


Vermeer bc1400

flushcut

flushcut

Addicted to ArboristSite
Joined
Dec 20, 2009
Messages
2,049
Location
Delavan, wi
You have an air leak somewhere. I would replace the bushings in the fuel lines behind the engine where your filter is located.
 
Eq Broker

Eq Broker

GlobalEquip
Joined
May 5, 2009
Messages
601
Location
Marietta
Website
www.globalequipmentexporters.com
If there is a Murphy switch, it could be shutting the engine off as well. Could be a bad Murphy switch, low oil pressure, or low voltage. The Murphy switch also senses high temp as well. I doubt this is the problem as it would take more than 5 minutes to get high temps unless, there's a bad sending unit.

Hope this helps!

Dave
Global Equipment Exporters
770-420-6400
 
Top