woodyman
Addicted to ArboristSite
I have a cylinder that should be a 372xpw 75cc.I don't know if its an early one or latter.Anyone know?Heres the numbers and letters on the jug.
7 K
502K6
W5T
Mahale
3
V
A5
7 K
502K6
W5T
Mahale
3
V
A5
I will recheck it and get back to you.Thanks.I have three of the 75cc cylinders and all mine say:
50ZK6
W6+
Are you sure yours says "T" and not "+"?
Mahle usually marks an oversize cylinder with a + sign.
I have three of the 75cc cylinders and all mine say:
50ZK6
W6+
Are you sure yours says "T" and not "+"?
Mahle usually marks an oversize cylinder with a + sign.
and jj are any of those cylinders in need of a loving home such as mine?
Rechecked mine and its the same as yours.Is it the one with the good port timing?And I have seen some with 372xpw and 375xp on the recoil cover.Did they make them both ways?
None of these belong to me personally. One is off my brother's saw, two are already headed out to or are committed to customers.
The 375 recoil logo was available from the factory after the 372XPW was already introduced. People have been buying the stickers
and retrofitting. I haven't seen a 375 chainsaw sold new in a dealership, or one marked as a 375. I've only seen the 372XPW.
These run ok stock but like Terry said, they run a lot better after they've been worked over.
I have three of the 75cc cylinders and all mine say:
50ZK6
W6+
Are you sure yours says "T" and not "+"?
Mahle usually marks an oversize cylinder with a + sign.
If the cylinder is stihl on the chainsaw, you can measure the bore by removing the muffler and sticking a pencil in the exhaust and clamping just enough on the pencil with the piston to put a mark on it. Then measure the pencil to see what the bore is.
You're looking for this on your cylinder :hmm3grin2orange::hmm3grin2orange::hmm3grin2orange:
You mean the blue ink anyone could put on it, or the rest of the saw?
Thought I did pretty well with just the muffler and a/v spring attached to it for 10 bux -- even if it is for 365.
You're looking for this on your cylinder :hmm3grin2orange::hmm3grin2orange::hmm3grin2orange:
You mean the blue ink anyone could put on it, or the rest of the saw?
Thought I did pretty well with just the muffler and a/v spring attached to it for 10 bux -- even if it is for 365.
No doubt 10 bucks is a good deal for what you got
Enter your email address to join: