Merc1100sc
ArboristSite Lurker
Hello all.
I am trying to figure out a craftsman 358.354830 for my father in law. The saw is in good condition.
It will start after a bunch of pulls with the choke full on. After a few seconds it will idle and rev pretty well with the choke off.
Once it warms up it wants to bog upon applying throttle. I've played with the mixture screws with no luck. It gets to the point where it will just die while squeezing the throttle and will not restart.
It has good spark. Has 150ccp and about 140 once warm. Piston/cylinder wall looks good. No excessive carbon build up in the exhaust area.
We rebuilt the walbro carb a year ago and it worked great after that. I pulled it apart again last night and everything looked good. Everything was in place from what I could tell.
Any ideas what could be wrong with this thing?
THanks
I am trying to figure out a craftsman 358.354830 for my father in law. The saw is in good condition.
It will start after a bunch of pulls with the choke full on. After a few seconds it will idle and rev pretty well with the choke off.
Once it warms up it wants to bog upon applying throttle. I've played with the mixture screws with no luck. It gets to the point where it will just die while squeezing the throttle and will not restart.
It has good spark. Has 150ccp and about 140 once warm. Piston/cylinder wall looks good. No excessive carbon build up in the exhaust area.
We rebuilt the walbro carb a year ago and it worked great after that. I pulled it apart again last night and everything looked good. Everything was in place from what I could tell.
Any ideas what could be wrong with this thing?
THanks