drf255
BAD CAD
What type, size and brand are you guys using?
Also, what solution have you found to be best?
Also, what solution have you found to be best?
I have a cylinder here that is so dirty I have not unable to get the dirt off it. I tried mineral spirits and a wire brush and it wont do nothing!I have two and i used them for boxes nothing else , i clean the saws with a pressure washer and the carbs with mild air or a little clear gas, for me the ultrasonics is another ********
inside or outside ? if inside the mastermind trick works very good , if outside bakingsoda blasting , or some oxy but carefull with theese chemicalsI have a cylinder here that is so dirty I have not unable to get the dirt off it. I tried mineral spirits and a wire brush and it wont do nothing!
Outside. How about ammonia?inside or outside ? if inside the mastermind trick works very good , if outside bakingsoda blasting , or some oxy but carefull with theese chemicals
I would not use ammonia I had a buddy put a piston with the ring on it in and I like to have never got it off it turned the piston a super dark gray color.Outside. How about ammonia?
Same thing I use but make sure you don't leave aluminum soak overnight and flush them with water after running through the cleaner. It will darken the aluminum if not, however I haven't noticed a difference in how the parts function if they do darken.I've got the large one from HF.
Use Simple Green Pro HD in a 50/50 mix.
What type, size and brand are you guys using?
Also, what solution have you found to be best?
I have a cylinder here that is so dirty I have not unable to get the dirt off it. I tried mineral spirits and a wire brush and it wont do nothing!
where did u get that one?
i recently purchased a 7 gal one one the bay and have not received it or a response from seller
p.s. KTM cyls stacked behind tank??
Enter your email address to join: