bikemike
loud pipes save lives
Looks well taken care ofJust send up for stumping or millingView attachment 413757
Looks well taken care ofJust send up for stumping or millingView attachment 413757
I like how you tucked the exhaust away looks like a sleeper at kwik glance. Yeah i wasnt impressed with the stock 880 either. It has the torque but its slow stock for a 120cc. I could alot of hidden potential in one cuase there is no replacement for displacementThe owner only has a couple of tanks through the motor, he was very disappointed in how poor it performed... I'm hoping he will like it better now... It has just a standard woods port set for making stump power. It will wear a 6 ft bar when he gets it... I have to admit I like the pipe exhaust on this one. I rolled and welded it up. So what one of his to do next... 026, 046, 372, 395 or the jonsered version of a 338? Fun fun...
That was the way I got the saw. The muffler had the top corner on the cover by the exhaust burnt out.whats going on with the melted handle and hood
Finally finished up the 084 yesterday. I took it down to the log pile today. I'm still tuning it in, I have the idle screw all the way in and
I can't get it to idle up any more, any thoughts or suggestions?View attachment 413728
View attachment 413729
View attachment 413730
View attachment 413731
Id run it by him about a turbo. Dont need to refill a turboI stole that idea from Ed Heard, that motor does barks good now and has plenty of grunt (or I can add if needed via a NOS system). But it doesn't matter what I think, it matters what the owner thinks..... but he already has over 10 motors I've done.
Is that on a SAW!?!Bob cat t190 replace head gasket kit to find out the head is pitted from running to much on a bad gasket. We bought it this way View attachment 413763View attachment 413764
Finally finished up the 084 yesterday. I took it down to the log pile today. I'm still tuning it in, I have the idle screw all the way in and
I can't get it to idle up any more, any thoughts or suggestions?View attachment 413728
View attachment 413729
View attachment 413730
View attachment 413731
Does it makes dustyou ever see a turbo take in wood chips?...
Not totally but i think we have a trench cutter for it if that countsIs that on a SAW!?!
HOLY SCRAP!!!
Are you going to plate the jug exhaust side looks scored up but looks nice n shiny.Finished my 460 jug tonight.View attachment 413815View attachment 413816
I have never heard of those but if the gap on rings is too close. You could seize it up when ring expands and the gap has no for expansionAnybody have any gapless rings for an SXL?
Do I HAVE TO call on the Greeks ???
Yes you must have .005 to .008 gap I hear. And I'm sure anything is possible.I have never heard of those but if the gap on rings is too close. You could seize it up when ring expands and the gap has no for expansion
Enter your email address to join: