This may been have asked before but it is first I have ran into this kinda problem.
I have a customer's Husky 141 LE in the shop that overheated the coil and carburetor adpator plate (specific the impulse port of the adaptor) to point that plastic melted. I look for an air flow problem everything is clean and open. The saw runs very well since I replaced the coil and re-open the plugged impulse port.
My question could this have been caused running the saw with the wrong fuel mix ie too little oil?
I have a customer's Husky 141 LE in the shop that overheated the coil and carburetor adpator plate (specific the impulse port of the adaptor) to point that plastic melted. I look for an air flow problem everything is clean and open. The saw runs very well since I replaced the coil and re-open the plugged impulse port.
My question could this have been caused running the saw with the wrong fuel mix ie too little oil?