I turn the idle screw but nothing happens, i dont have the tools to do a pressure/vac testTurn the idle screw clockwise till you get 2800rpm or nicely settled to where the chain don't move. Many people don't believe they need a primer bulb on a 50cc saw so they disable them, l would leave it unless you have starting difficulties. lf your idle won't come down by adjusting the screw, you may have bigger problems and need a pressure/vac test. lf that is the case it should not be run untill its repaired.
Turn the idle screw clockwise till you get 2800rpm or nicely settled to where the chain don't move. Many people don't believe they need a primer bulb on a 50cc saw so they disable them, l would leave it unless you have starting difficulties. lf your idle won't come down by adjusting the screw, you may have bigger problems and need a pressure/vac test. lf that is the case it should not be run untill its repaired.
Can you take a pic of what you're talking about? That would be very helpful.What i found i dont know if this is right, the seal on the clucth side i can rotate it with my hand, is that correct?
Here are some picsCan you take a pic of what you're talking about? That would be very helpful.
What do you mean by radial play?That's the seal. Does the crank have any radial play?
Sent from my KFSOWI using Tapatalk
It should not have any side to side or in/out play/movement. If does, it needs bearings, but I've not run across a 346 with bad bearings and I've got a few of them with tons of hours.What do you mean by radial play?
It has side to side play but in and out doesnt.It should not have any side to side or in/out play/movement. If does, it needs bearings, but I've not run across a 346 with bad bearings and I've got a few of them with tons of hours.
Looks like a bad seal? Not hard to replace though.
Bad bearing then. Time to replace both crank bearings & seals.It has side to side play but in and out doesnt.
Yep, that's a bad bearing.I dont know if in video you can see but when i move the seal the bearing moves also.
I hope that only bearings and seals need to be replaced. Could be the case bad?Yep, that's a bad bearing.
Enter your email address to join: