When I am setting up the first cut on a 9 foot log with say one end being 14 inches and the other end being 15 or 16 inches with a gentle increase in diameter
With the first cut do I want to be consistent and take the same 1 or 2 inch amount off the whole log
or
do I want to take more off the big end and only a minimum off the small end?
I would most likely milling it as a small slab, leaving the live edge on both sides until the boards are committed to a project.
Not milling to make beams.
Thanks
With the first cut do I want to be consistent and take the same 1 or 2 inch amount off the whole log
or
do I want to take more off the big end and only a minimum off the small end?
I would most likely milling it as a small slab, leaving the live edge on both sides until the boards are committed to a project.
Not milling to make beams.
Thanks