Exophysical
ArboristSite Operative
My 365xt has started surging a bit. It does a little bit of surging at idle right after a cold start which goes away once it warms up, after that it idles and runs good unloaded at any RPM. In the wood however, at/ near full throttle the RPM's jump up every few seconds, then back dow etc. I did play with the carb tuning a bit, looking at the plug I could see a difference, but the saw continued to run pretty much the same whether I went 1/4 turn up or down (1/2 turn total variance). I checked it with a tach and WOT rpm is a little under 13000, so not running against the rev limiter.
Wondering where I should start looking? Thanks.
Wondering where I should start looking? Thanks.