Been trying to work on my MS200T recently, noticed that the chain cover doesn't sit flush to the body of the saw. Can't see anything blatantly blocking it, so I'm not sure what the issue is, whether it's warped or if there's a piece missing somewhere. Any ideas?
Hi gents,can anybody give me the p# for the 066 top cover?
It's for the second gen 066 that is flat top but has decomp hole.
I thought is was 11220801607 but I think this is the latest 660 hump cover.
Also the cover I need has a slightly wider bulge where it meets the starter housing.
The ipl...
the little stainless pin in the case that the fastener actually quarter turns on...is that included when you buy the fastener, or is it a separate part...and who has the part number? I don’t see it on a diagram.
Also, does anyone have a 362c non mtronic shroud/cover with the 3 twist locks in...
Im looking for a good used west coast cover with now cracks or breaks, doesnt matter if it has a lot of paint wear as long as its not beat up. I am having an 064 powder coated and want everything to be the same color "Bone White" so its less noticeable it isnt OEM.
I have four complete and one just cover. the one in the lower right corner shows no handle but has a new one on it now. would like to get $35 plus half the ride for the completes and $15 plus the shipping for the cover only
For Sale today is one slighty used starter cover for a 575xp. no handle, bad rope, bad pulley. BUT! I has a sticker and screws! would like 25.00 shipped to you!