066 Second Gen cover.

[L34]

Hi gents,can anybody give me the p# for the 066 top cover?
It's for the second gen 066 that is flat top but has decomp hole.
I thought is was 11220801607 but I think this is the latest 660 hump cover.
Also the cover I need has a slightly wider bulge where it meets the starter housing.
The ipl only shows the above p# but there are several covers depending on 066/660 model.
Thanks in advance,Chris.

 

[Jacob J.]

Chris -

I think the cover you're referring to is: 1122 080 1606.

This would be the flat-top with compression release for the last of the metal flywheel saws and the early poly flywheel rigs.

 

[president]

Chris -

I think the cover you're referring to is: 1122 080 1606.

This would be the flat-top with compression release for the last of the metal flywheel saws and the early poly flywheel rigs.

I have the earley poly fw flat top decomp saw ,did it run stronger than the latter
saws in that series?

 

[pioneerguy600]

I have the earley poly fw flat top decomp saw ,did it run stronger than the latter
saws in that series?

Sure does, well mine does.

 

[L34]

Chris -

I think the cover you're referring to is: 1122 080 1606.

This would be the flat-top with compression release for the last of the metal flywheel saws and the early poly flywheel rigs.

Yes small tank large crank saw.

 

[L34]

Thanks gents.

 

[L34]

@Jacob J.
Hard time finding one here down under.
Not going to pay crazy shipping prices if I locate a good one in USA or Europe.