scooby533
ArboristSite Member
I picked this cylinder up today for 20$. I did not notice the insert at the garage sale until i got home and cleaned it up. The insert protrudes down into the combustion chamber pretty good. I’ve never ran a saw with an insert, never needed to. I figure I’ll have to take the crush washer off the plug to to get it to sit down in the cylinder as close to stock as possible. Thoughts?
I’m actually thinking of removing the insert and machining off .080” or so.
Otherwise, it’s an early 10mm KS cylinder that should run well.
I’m actually thinking of removing the insert and machining off .080” or so.
Otherwise, it’s an early 10mm KS cylinder that should run well.