Sticky?
That is quite a compliment. Let's wait and see how it turns out.
It's a pretty simple step by step procedure. The main thing is to be patient and break it up into three pours. Here is pour #3:
A view of the pour site.
Need to plug this hole to allow for handle reassembly and later service.
A two stage plug to fill the hole and allow a channel for reinstallation of the screw. I need to allow space for the JB to fully enclose the reinforcing wire.
Packing the clay into the hole to ensure a quality result.
Placing a small dam to allow some pour depth at the bottom. Can be ground off later. So much for no sanding required....LOL
That is quite a compliment. Let's wait and see how it turns out.
It's a pretty simple step by step procedure. The main thing is to be patient and break it up into three pours. Here is pour #3:
A view of the pour site.
Need to plug this hole to allow for handle reassembly and later service.
A two stage plug to fill the hole and allow a channel for reinstallation of the screw. I need to allow space for the JB to fully enclose the reinforcing wire.
Packing the clay into the hole to ensure a quality result.
Placing a small dam to allow some pour depth at the bottom. Can be ground off later. So much for no sanding required....LOL
Last edited: