Any 044 experts care to chime in on what I got here?
I’m thinking non decomp 12mm
12mm
Did you sand that jug?
Any 044 experts care to chime in on what I got here?
I’m thinking non decomp 12mm
12mm
Did you sand that jug?
Looks like 80 grit.
Small hole in nickasil under ex port?
No lol that’s what I was thinking it looked like someone sanded it I’m not that stupid haha. I had literally just pulled it apart and cleaned.
Looks like 80 grit.
Small hole in nickasil under ex port?
I think no matter what anyone says your mind is already made up. You'll use it.I have ran them with good success with a small hole in nikasil, as long as nothing catches your fingernail. But I’m not sure if they went too far with the hone on this would probably eat rings, although the piston and rings did look good except where the wrist pin bearing got jammed in between piston and cylinder. I’m not quite sure what I think about this jug. I may take some 3000grit to it. I think it def could be saved. What do y’all think?
Enter your email address to join: