046 mag w 8 pin and 25" action

[Jkstihl]

Yall sorry if i post alot but i cant talk saws w the ol lady.

046 d jug 3 pole coil base delete muff mod soon to have a timing advance.

I think she pulls it with authority, what about yall? This is just a preview will get some good videos tmw in the daylight. I was putting some weight to her in the vid.

 

[toolmaker]

Nice vid!! Ya, it pulls hard!
PS. If you tuck your pant legs outside the boots you will have less splinters in your socks!! LOL!!

 

[Jkstihl]

Nice vid!! Ya, it pulls hard!
PS. If you tuck your pant legs outside the boots you will have less splinters in your socks!! LOL!!

Haha i know i just slipped em on to do this vid, dont usually wear em like that.

 

[blsnelling]

It'll pull it just fine. But, a 7-pin will be faster unless cutting small wood.

 

[Gypo Logger]

9 pin 13”-16”. That will make the oiler get up and talk!
And I wish people wood stop saying “pin”, when referring to a 7 or 8 tooth sprocket! The only sprockets that have “pins” are 9 tooth and up with the possible exception of a 9 tooth 325.
So stop saying “pin”, or I’ll be coming down there!

 

[Jkstihl]

9 pin 13”-16”. That will make the oiler get up and talk!
And I wish people wood stop saying “pin”, when referring to a 7 or 8 tooth sprocket! The only sprockets that have “pins” are 9 tooth and up with the possible exception of a 9 tooth 325.
So stop saying “pin”, or I’ll be coming down there!

Haha bad habits are hard to break, it definitely doesnt have any pins in it. How about 8 pocket? Lol

 

[cuinrearview]

Hmmmmm.... are your boots untied?

 

[Jkstihl]

Hmmmmm.... are your boots untied?

Im not quite sure how to answer that. Is this a trick question? Lol