Want to Buy 16" x3/8x.05 Homie EZ bar

[hanniedog]

Want sprocket nose bar.

 

[Bill G]

Homelite brand or does it matter

 

[Brushwacker]

I have a couple 16" OEM Homelite bars old stock w/ some shelf wear but unused. P/N A60T 7052 SP16381-H6 on 1, other mounts the same but is darker. If that is the right mount , would send 1 to Ohio $25.to $30 shipped. I had a 20" with the same mount on my Dolmar 5100 if that helps ID the pattern.
Also have an 18" with an open slot and squarish in front of the mount, P/N 18 37 043 64.

 

[hanniedog]

Would like Homie brand.

 

[KYsawman]

@chainsawlady here on the forum has them, nos homelite sprocket nose, shoot her a message.

 

[svk]

Are you looking for a perfect one, or a nice one with some writing left?

 

[undee70ss]

I have a couple 16" OEM Homelite bars old stock w/ some shelf wear but unused. P/N A60T 7052 SP16381-H6 on 1, other mounts the same but is darker. If that is the right mount , would send 1 to Ohio $25.to $30 shipped. I had a 20" with the same mount on my Dolmar 5100 if that helps ID the pattern.
Also have an 18" with an open slot and squarish in front of the mount, P/N 18 37 043 64.

The SP16381-H6 fits the 290-340 Homelite saws (solo built), and is for 3/8 pitch chain. The 18 37 043 64 fits the XL, XL2 Super 2 series of saws, and is for 3/8 lo pro chain. For original Homlite bars, the last number is the mount pattern. The OP needs the 3 mount pattern, EZ, Super EZ, XL101, XL102 ect.. series of saws.

 

[Modifiedmark]

Here is what I have left. I had a few of these a while ago and they brought big money as far as I'm concerned. These don't have to be big money though and are in good shape. These are the last two I have and are both 16" 3/8 .050 59DL.

The one without lettering is used but is a very nice bar. The other was new but has some surface staining from storage and has some extra adjuster holes in it from a experiment. It will work just fine on your Super EZ/EZ