262xp hard to start after it gets hot

[2rod511]

I have a 262xp that is a pain to start after the saw has been worked for a little while. I have changed the fuel line, cleaned the carb, and checked everything I can think of, it just isn't getting enough gas to stay running between when I pull the handle and when I get my hand to the trigger.The saw has a strong motor (it will pull the handle from your hand if you dont get a good pull on it when cranking). It has been getting worse and worse for quite some time and really showed her arse earlier today, just wondering if anyone else had come across this and had some suggestions. Thanks in advance.

 

[almondgt]

Change the spark plug............that's all I got

 

[2rod511]

Dont think its the fire (havent tried that though) however, I believe it is related to the saw being fuel deprived or getting air from somewhere.

 

[almondgt]

Replace with a ws7f bosch spark plug and betcha you'll be a happy 262 owner,.........again there is no miracle cures on this site!

 

[johnnichols]

Sounds like an air leak to me. Both my 261 and 262xp showed same signs and had bad crank seals. Suggest a vacumm/pressure test.