2broke2ride
Addicted to ArboristSite
- Joined
- Jul 20, 2014
- Messages
- 1,862
- Reaction score
- 2,491
I'm rebuilding this saw for a friend and I'm planning to do some minor port work. I'm totally new to this and my friend understands and is ok with it.
I am planning to just clean up the intake andnexhaist without changing the port shapes. I'm not going to mess with upper transfers either because I lack tools to get in there and I'm nervous about messing up the cylinder liner. I am going to case match the lower transfers and knife edge the divider. I am also planning to delete the base gasket if squish allows and mod the muffler.
Does all of this sound reasonable? Last thing I want to do is end up with a doorstop.
I am planning to just clean up the intake andnexhaist without changing the port shapes. I'm not going to mess with upper transfers either because I lack tools to get in there and I'm nervous about messing up the cylinder liner. I am going to case match the lower transfers and knife edge the divider. I am also planning to delete the base gasket if squish allows and mod the muffler.
Does all of this sound reasonable? Last thing I want to do is end up with a doorstop.