Basically here's the story, my 562 ran sweet, no problems at all, very happy with the saw, except for the hot start issue, which is of cause easy to get around by using high idle to start it.
But because I'm picky, I thought I would take it in and see what could be done under warranty.
They said the coil was an issue, so they put the new version carby in, new coil and wiring and updated software, which I thought great..
I went to pick it up, and they said I might it could bog down for a second or two when grabbing onto the throttle, then I asked if they could put the saw to a real world test, so they took it out back and ran about 4 cuts through a 6inch log, now when he stopped after the last cut, releasing the throttle the saw seem to run in high idle (chain still spinning) for about 3 seconds, then went into idle (and chain stopping)
He said, it could just need more time for the saw to tune itself and settle in...
Now I'm interested to see what your comment is?
But because I'm picky, I thought I would take it in and see what could be done under warranty.
They said the coil was an issue, so they put the new version carby in, new coil and wiring and updated software, which I thought great..
I went to pick it up, and they said I might it could bog down for a second or two when grabbing onto the throttle, then I asked if they could put the saw to a real world test, so they took it out back and ran about 4 cuts through a 6inch log, now when he stopped after the last cut, releasing the throttle the saw seem to run in high idle (chain still spinning) for about 3 seconds, then went into idle (and chain stopping)
He said, it could just need more time for the saw to tune itself and settle in...
Now I'm interested to see what your comment is?