golfmech
New Member
Hello all! I am at a golf course on Long Island. I have a Husky 575xp with a 28" bar. It mostly is used in a milling jig. The operator was running the saw when it suddenly stalled and he was never able to get it started again. In the past this same saw ate up a piston/cylinder. This time the piston/cylinder looked ok, but I replaced them anyway (had a kit on the shelf). If I choke it and pull the starter 3-4 times then turn off the choke and pull the starter it fires up for about 1 second. That's all I can get it to do. I have removed and rebuilt the carb with the same results. It appears to have good spark, changed the plug anyway. Compression appears fine. Any help here would be great.