Well men ,Just to up date you guys ,I think the worst is over i hope for now !All of the blades seem to be doing there job now even most of the problem blades!
I upped the the rpms on the wheels 1/3 and am thinking I may do one more pulley change ,and drop from 8.75 to 7.75 pulley to get just a little more out of it Im running approx 830 rpms no load now and a little fluid left to spare (Not MUCH)to run the height control.The drop should enable me to get a decent amount of oil to run the height control no problem , keep the saw at the 4800 to 5000 bfpm and keep the tractor rpms where I'd like em. 12- 1300
Again thanx for the help!
And the input.
Fred
I upped the the rpms on the wheels 1/3 and am thinking I may do one more pulley change ,and drop from 8.75 to 7.75 pulley to get just a little more out of it Im running approx 830 rpms no load now and a little fluid left to spare (Not MUCH)to run the height control.The drop should enable me to get a decent amount of oil to run the height control no problem , keep the saw at the 4800 to 5000 bfpm and keep the tractor rpms where I'd like em. 12- 1300
Again thanx for the help!
And the input.
Fred