Bar I.D. help

[slabracing]

I was looking through some old equipment today and came across a windsor bar w/28jr58sna stamped on it.
Can anybody tell me what mount this is ie large husky etc..
Thanks in advance
Dave

 

[Urbicide]

You probably are aware that your 6400 takes the large mount Husky bar. See if the bar in question will mount up. I think the "58" in the number might be the guage of the bar (.058).

 

[olyman]

go to www.acresinternet.com on start page--go to chainsaw models----at the top of that page--it says bar mount patterns----and if you look up your saw on his site--it will tell the bar mount pattern---

 

[ray benson]

28JR58SNA crosses to a D024 mount and is listed fitting Jonsereds 60,62,75,601,751,M80,M110,M111,M111s saws. 28" bar, .058 gauge, speedtip bar. 90 drive link chain if 3/8 pitch. 81 drive link chain if .404 pitch. Info is out of an old Windsor catalog.

 

[SawTroll]

28JR58SNA crosses to a D024 mount and is listed fitting Jonsereds 60,62,75,601,751,M80,M110,M111,M111s saws. 28" bar, .058 gauge, speedtip bar. 90 drive link chain if 3/8 pitch. 81 drive link chain if .404 pitch. Info is out of an old Windsor catalog.

Good info, but the 621 is missing on that list, and I believe some others are, also...........

 

[slabracing]

Thanks

Thank you to everybody who responded
This site rocks