Hi all!
I need some help with an old Stihl MS260.
I got it for near free and it's used but working, after some cleanup/carb replacement etc.
Anyho, my problem is that the threading in the hole for the oil plate, see picture 2, has been wrecked inside.
This means that the plate is loose, and the M4*8 screw holding the plate simply doesnt work in the hole anymore.
I have made an M4*11 screw, that does hold the plate, probably because the threading in the end isn't too worn out/broken yet.
But, will this solution last? Or is there a better workaround here?
Thanks for all help!
I need some help with an old Stihl MS260.
I got it for near free and it's used but working, after some cleanup/carb replacement etc.
Anyho, my problem is that the threading in the hole for the oil plate, see picture 2, has been wrecked inside.
This means that the plate is loose, and the M4*8 screw holding the plate simply doesnt work in the hole anymore.
I have made an M4*11 screw, that does hold the plate, probably because the threading in the end isn't too worn out/broken yet.
But, will this solution last? Or is there a better workaround here?
Thanks for all help!