Chain favored for 350 Husky

[Jensent]

I have a 350 Husky w/18in bar. It runs .325x.050. What is your favorite in this size chain on this 50cc saw. I cut 7 to 10 cords of stove wood per year. Wood is dropped in our yard by local tree service. Wood is handled by crane and not dragged but we still run into rot and dirt that is hard on chains. We use 63pm3 (Stihl picco) on our 021 and Dolmar 420. It seems to stay sharp.
Thanks
Tom

 

[AuerX]

The Husqvarna H25 has been my favorite all around chain on my 340.

I run a 16" bar.

 

[computeruser]

Oregon 20lpx.

 

[Modifiedmark]

I would agree on the 20LPX except the part about the wood not being clean.

In that case I think I would go with the Oregon 95vp (Husqvarna H30 if I remember right). Its a narrow kerf semi chisel that came original to most 350's. Cuts fast and holds a good edge, I used it to cut out of brush piles and liked it quite a bit.

You will need a narrow kerf bar to run it on though.