chainsaw problems

[turtleman]

poulan farmhand 2775 i know most saws have carb adj close to being the same but when i checked the high speed adj on this one it was 3 and 1/2 turns counter clockwise that seems a bit much to me i have a poulan pro 295 and it's adj is 1 and 3/4 on high it has been running good at this setting for 2 yr's i would appreceate any info on the poulan 2775

 

[Vintage Engine Repairs]

Depends if the carb is a dependant carby, what’s the make and model ?

 

[turtleman]

Depends if the carb is a dependant carby, what’s the make and model ?

poulan farmhand 2775 made in 1999 it's 46cc the only no's. on tage are family no. xpwes o464cs em serial no. 99167n100661-1 the carb has a high and low speed air jet i would just like the pre set settings thank you

 

[heimannm]

Several of the Plastic Poulans have adjustments that are far from the norm. I suspect the 3 or 3-12 is correct for that model.

Mark

 

[Old2stroke]

If it's a strato engine (two intake ports on the carb), three turns out on the high speed screw can be normal.

 

[turtleman]

Several of the Plastic Poulans have adjustments that are far from the norm. I suspect the 3 or 3-12 is correct for that model.

Mark

thanks a lot it was 3 turns just wanted to make sure

 

[turtleman]

If it's a strato engine (two intake ports on the carb), three turns out on the high speed screw can be normal.

thanks i'll check i am getting ready to clean the carb. it was 3 turns on high just wanted to make sure

 

[turtleman]

thanks to everyone for your support this is the best forum i have been in