Cheap but reliable

[kicktrees]

I have an old craftsman 16" that I just use for small limbs because it weighs nothing and always starts until just recently. I replaced the plug cleaned the screen and it starts but only for a little. It starts in choke then will die. Did I need to gap the plug if so does anyone know where I can get the specs or is there anything else I can do to get it back in order. I have used this saw for two years with no issues.

 

[carvinmark]

Welcome to AS,
Sounds like a fuel supply problem, I would clean out the fuel tank and replace the fuel filter(it should be in the fuel tank). You will get plenty of good quality advice here as others will reply tomorrow. Good luck,
Markopcorn:

 

[Brit101]

Welcome to AS,

x2
http://www.acresinternet.com/cscc.nsf/GasbyManufacturer?OpenView&Start=1&Count=30&Expand=23#23
Should have your model # there with specs on your saw.