Conversion question

[WiCkEd-cLoWn]

I have a MAC 3516 (love it my favorate saw)

and I have a Polland Pro 295 (hate it) :blob5:

the PP295 has a 20" bar and chain can it be coverted to a 16" bar and chain?
If so is it by any chance posible to convert it to the same sprocket, bar and chain as the MAC 3516 ?

 

[Marco]

Yes
No

 

[p38lightning]

I just converted a Mac 250 to a 3/8 pitch sprocket, maybe you can also. I just don't know alot about MACS. The sprocket was a spur type made by Oregon.

 

[Lawn Masters]

The poulan uses a 9mm mounting slot, the Mac, a 1/4" slot, this is a no go right here. chain pitch, probably, IF you've got a rim sprocket on it and a rim of the pitch desired on hand.

 

[WiCkEd-cLoWn]

ok figure that the same wouldn't work but atleast converting it to a 16" bar would be great does any one know the part numbers for the proper sprocket, bar, and chains needed to do this?

 

[TimberPig]

http://www.oregonchain.com/selguide.htm

Try going here and filling it out, you'll get all the info you need for Oregon.

or www.windsorforestry.com
and find their selector guide.

 

[pallis]

Get a chain tensioner to put on your 295, and put a rim sprocket on it. That's what I did. I just went into my Husky dealer's, and found a rim sprocket set up to fit it. I'm presently running it with a 14" bar and the low profile 3/8s chain.

 

[WiCkEd-cLoWn]

http://www.oregonchain.com/selguide.htm

Try going here and filling it out, you'll get all the info you need for Oregon.

or www.windsorforestry.com
and find their selector guide.

Thank You very much for the help/links very much apreciated found all the parts i needed. :jester:

 

[bugfart]

This is worse than a Burgerking commercial.

 

[spacemule]

That is the most obnoxious singature I've ever seen.