neelix
ArboristSite Lurker
The saw is pretty much new but has never run correctly. Less than 2 tanks used.
It idles fine and the low speed response is alright but not perfect, the high speed is useless and the direction in the owners manual don't seem to help at all, it will load up and bog under no load, seems to run a bit cleaner with the air filter assembly removed but still not the way it should. So am I correct to assume it is running rich on the high? And leaning it out by turning the H screw clockwise should help (it didn't') when I tried it? Again the OM doesn't't state which way is lean,and the adjustment range is limited because of the plastic emission tabs. Also I remember you can open up the exhaust and they run much better what is the process for doing this.
Thanks for your help I have about 15 large trees which will have to be cut down this spring because of the massive ice storm damage we had in the NE.
Regards
Rob
It idles fine and the low speed response is alright but not perfect, the high speed is useless and the direction in the owners manual don't seem to help at all, it will load up and bog under no load, seems to run a bit cleaner with the air filter assembly removed but still not the way it should. So am I correct to assume it is running rich on the high? And leaning it out by turning the H screw clockwise should help (it didn't') when I tried it? Again the OM doesn't't state which way is lean,and the adjustment range is limited because of the plastic emission tabs. Also I remember you can open up the exhaust and they run much better what is the process for doing this.
Thanks for your help I have about 15 large trees which will have to be cut down this spring because of the massive ice storm damage we had in the NE.
Regards
Rob