Joshua Tabora
ArboristSite Member
I tightened the High and Low jets absentmindedly when I was rebuilding a carburetor. If the seats were damaged, what symptoms should I expect to see?
Damaged carburetor seat?
- Thread starter Joshua Tabora
- Start date
Help Support Arborist Forum:
You mean mixture screws, right?
*
You'll probably be fine, unless you really tightened the piss out of them.
*
It can deform the aluminum seats that allow for precise, and consistently predictable mixture results.
*
If you over tighten a mixture screw, then for instance; the factory recommended "one turn out" resulting mixture may not be the same as an "unadulterated" carb. lol
*
You'll probably be fine, unless you really tightened the piss out of them.
*
It can deform the aluminum seats that allow for precise, and consistently predictable mixture results.
*
If you over tighten a mixture screw, then for instance; the factory recommended "one turn out" resulting mixture may not be the same as an "unadulterated" carb. lol
