Eager Beaver 2.1

[edmxz2002]

Hi all,
I got a little Eager Beaver 2.1 for helping clean out a friends dads garage.
It's in great condition and looks like it might have been used very little.
I put in a little gas ( the tank was empty and clean) and it started and runs great.
I pushed the manual oil button and it pumped out oil.
I have a couple questions. Should it have an auto oiler? The screw to adjust the oil flow is missing or broken off. I didn't have time to check it out but will play with it when I get home.
Is it worth keeping? What would you expect it to sell for if I don't keep it?
Some pictures attached.

Thanks, Ed

 

[TheJollyLogger]

Hi all,

I got a little Eager Beaver 2.1 for helping clean out a friends dads garage.

It's in great condition and looks like it might have been used very little.

I put in a little gas ( the tank was empty and clean) and it started and runs great.

I pushed the manual oil button and it pumped out oil.

I have a couple questions. Should it have an auto oiler? The screw to adjust the oil flow is missing or broken off. I didn't have time to check it out but will play with it when I get home.

Is it worth keeping? What would you expect it to sell for if I don't keep it?

Some pictures attached.



Thanks, Ed


You'll get more help in the chainsaw forum

 

[edmxz2002]

Thanks, new here and wasn't sure where to post.

 

[heimannm]

I just saw this post.

There is a small hole in the front of the saw to access the adjustment screw for the automatic oil pump.



Mark

 

[edmxz2002]

It looks like the screw has broken off. I don't see anything in there that could turn.

 

[heimannm]

It is not a large screw (Item 6), and it may be burried down in there.



Mark