TimTaylor
ArboristSite Operative
Look what I found. In with some scrap and old weed eaters at the recyclers
Sent from my HUAWEI VNS-L22 using Tapatalk
Sent from my HUAWEI VNS-L22 using Tapatalk
Two ms200t p&cs plus a whole lot of oil pumps tanks and clutches.Look what I found. In with some scrap and old weed eaters at the recyclers
Sent from my HUAWEI VNS-L22 using Tapatalk
Ok so some of the bits are AM but most of it is genuine and it looks ok.
Sent from my HUAWEI VNS-L22 using Tapatalk
My question stems from their reason for not having the 200t kit on the market. I would have to go back over many messages but I recall it being the way the handle attached. Good on yaAll of the bits that weren't there are and farmertec except for the throttle linkages and carb cover. I had to make the throttle linkages, out of old bike spokes, and I found the carb cover on the NZ trading site (cost me $45) the throttle linkages I just couldn't find, even new and they were a major pain to get right. I'm still missing the rubber bit at the base of the handle.
The handle was ok, it didn't fit quite right , it leans over to one side slightly but its hard to notice and you don't notice when using it.
Sent from my HUAWEI VNS-L22 using Tapatalk
$45 wowAll of the bits that weren't there are and farmertec except for the throttle linkages and carb cover. I had to make the throttle linkages, out of old bike spokes, and I found the carb cover on the NZ trading site (cost me $45) the throttle linkages I just couldn't find, even new and they were a major pain to get right. I'm still missing the rubber bit at the base of the handle.
The handle was ok, it didn't fit quite right , it leans over to one side slightly but its hard to notice and you don't notice when using it.
Sent from my HUAWEI VNS-L22 using Tapatalk
I would imagine that the handle is giving them grief. If they had the throttle bits and electrical contacts etc that would have made life much easier, also I'm picking its the fibre and resin side handle that is the problem, I think its shrunk slightly after manufacture, and that pulls it all to one side. But the quality is much better than the other copy bits I've seenMy question stems from their reason for not having the 200t kit on the market. I would have to go back over many messages but I recall it being the way the handle attached. Good on ya
Yeah, but in your dollars that's only $26 or so and Stihl parts in nz are frightening.$45 wow
And I figure I've saved another saw and I have the important spares, and it has cost me less than $150 (nz)Yeah, but in your dollars that's only $26 or so and Stihl parts in nz are frightening.
Sent from my HUAWEI VNS-L22 using Tapatalk
No, just bringing some levity to the post.....OMG and you brought them home? lol
You do realise one of them is upside down? Not that it was me that noticed though....No, just bringing some levity to the post.....
Me tooNo, just bringing some levity to the post.....
........You do realise one of them is upside down? Not that it was me that noticed though....
Sent from my HUAWEI VNS-L22 using Tapatalk
Enter your email address to join: