Softdraw
ArboristSite Member
I replaced the purge bulb on a poulan pro pr5020. The saw sat unused for a while and the bulb cracked. Prior to that, the saw ran great. After I replaced the bulb, I can start the saw easily but it stalls almost immediately as the gas I choked into the carb burns. choking the saw to start is like giving the engine a shot of gasoline. After it starts, the saw quits. Could this be because I reversed the fuel lines? I can draw gas into the carb to start but I can’t get any fuel from the tank to the cylinder after that. Is this a bulb /fuel line issue or something else?