pigeon_No_9
ArboristSite Lurker
Hello,
Sorry if I'm stretching the boundaries about what belongs in this forum, but I'm in a situation where I would need quick solution.
Changing head for Briggs and Stratton mower - head bolts should be tightened to ~11.8 ft-lbs (16nm). My dynamometric wrench starts at 14,75 ft-lbs (20nm) - do I yolo it and hope for the best?
Is there a real risk of this small difference to strip out the bolts?
Hope someone can help within next few hours.
Cheers
Sorry if I'm stretching the boundaries about what belongs in this forum, but I'm in a situation where I would need quick solution.
Changing head for Briggs and Stratton mower - head bolts should be tightened to ~11.8 ft-lbs (16nm). My dynamometric wrench starts at 14,75 ft-lbs (20nm) - do I yolo it and hope for the best?
Is there a real risk of this small difference to strip out the bolts?
Hope someone can help within next few hours.
Cheers