Hello I’m new to this site. I just got done building a house and installed a Hotblast 1557 wood furnace. I can’t seam to figure this thing out. I’m not able to get long burns and even if I load it full it seams to eat though wood. If I close the damper down it still eats wood. It also smokes a lot and doesn’t burn very clean. Can’t get the flue temperature very hot runs in creosote range. And if I run it with the damper open it just runs through wood and the heat goes right up the chimney. After 7 days of burning I have a lot of creosote build up. Please any help would be great on how to work one of these things