husky 281xp cylinder torque????

[67camaro]

I'm rebuilding the upper end on mu husky 281xp.I need to know what to torque the jug down to.Thanks for any help.I'm new to rebuilding saws.I used to just throw them out when they blew up.

 

[timberwolf]

Don't know what the manual says, but for general metric bolts:

http://www.boltdepot.com/fastener-information/Metric-Recommended-Torque.htm

If it is a 5mm metric you would be looking at about 6 ft/lb.

1 ft lb =1.36 nm

 

[ray benson]

Manual calls for 11nm - 8.1 ft. lbs.

 

[SawTroll]

This workshop manual may be helpfull.