Husky 346

[WKEND LUMBERJAK]

I picked up a Husky 346 dosen't appear to have been run much. What are the Normal porting # on a stock saw ie.. squish, exaust, transfer and intake open. Thinking about pulling the gasket and Playing with the ports. Don't have a good compression tester.

 

[Hedgerow]

.

 

[WKEND LUMBERJAK]

The # on the one I am looking at are

Ex opens 100*
duration 150
Transfers open 120*
duration 102
Intake opens 104*
duration145
Squish is .029

Cylinder and piston look good.

 

[Hedgerow]

The # on the one I am looking at are

Ex opens 100*
duration 150
Transfers open 120*
duration 102
Intake opens 104*
duration145
Squish is .029

Cylinder and piston look good.

Are you sure that squish is right? Too tight unless the base gasket has been removed already...

 

[WKEND LUMBERJAK]

Are you sure that squish is right? Too tight unless the base gasket has been removed already...

Just rechecked got 30 this time pulled cylinder it has a paper type gasket. Cylinder says Malhe SC.