I just installed a new zama carb on my husky 357. I can't get it to seal. I'm afraid to over tighten the carb screws. They self thread into a plastic flange. I just ordered the ring on the bellows. I assume that's where I have the leak. No gasket, but a little cheap plastic ring. Any tricks to try while I'm waiting for the part? Can I apply some sealant on the ring?
I'm not impressed by the cheapness of this saw. Plastic which can be removed and re-installed only a few times. I have two old husky 61's that are built much better than this 357.
I'm not impressed by the cheapness of this saw. Plastic which can be removed and re-installed only a few times. I have two old husky 61's that are built much better than this 357.