Up for sale is a Husky 365 Special. The saw is a strong runner, cuts and oils well but it can be hard to start. Might just be a carb kit, but I haven't bothered checking. It's all oem outside of gaskets/seals, and the only thing that might be a concern is the muffler mod points right at what you're cutting. The pto side case half had the upper screw fall out along with a large piece of the case while my brother was bucking firewood with it so I swapped the case half a few months back. While I was in there I installed new FAG bearings and a Hyway gasket/seal kit. Note: this is the variant with an intake boot, not an intake block.
I'd like to get $400 + the ride for it, but I'm open to offers.
I'd like to get $400 + the ride for it, but I'm open to offers.
