This saw has new crank bearings, seals, Meteor piston, and new rubber mounts. Cylinder base/chamber have been cut to up the compression to 195 and the port timing set back to stock. The saw runs good but I do believe it needs a carb. I put a kit in the carb but it still acts funny when tuning. I put a 385xp bar plate on it and a new air filter. The clutch cover has a piece missing at the bottom and a small piece missing right at the chain brake lever. I also used covers from different saws so they are faded different but that's typical with Husqvarna's.
In the last pic it shows the spark plug threads. The top few are stripped out but the plug threads in just fine and tightens up.
Please make me a reasonable offer or trade.
In the last pic it shows the spark plug threads. The top few are stripped out but the plug threads in just fine and tightens up.
Please make me a reasonable offer or trade.