I moved this over from the handheld equipment forum since it’s basically a chainsaw and this page gets a lot more traffic. Delete if not allowed.
I am working on my neighbor’s concrete saw that wasn’t running. P&C were toast so I swapped them out with aftermarket. Now I have the jug back on and pressure testing the crank case and it won’t hold pressure. Found the leak location with soap bubble but can not figure out for the life of me what the purpose of this ball bearing type thing is. I tested the old cylinder and it held pressure from both directions.
Can someone shed light on this and how I can go about fixing this leak?
Thank you
I am working on my neighbor’s concrete saw that wasn’t running. P&C were toast so I swapped them out with aftermarket. Now I have the jug back on and pressure testing the crank case and it won’t hold pressure. Found the leak location with soap bubble but can not figure out for the life of me what the purpose of this ball bearing type thing is. I tested the old cylinder and it held pressure from both directions.
Can someone shed light on this and how I can go about fixing this leak?
Thank you