neutral4x4
ArboristSite Operative
I have a question for you guys. It doesn't specifically have to do with saws in my case, but it could apply to any 2 stroke I guess.
Is it possible to add an exhaust bridge to a cast iron cylinder with a single port? I've never done it.
Is it possible to weld anything in there with any accuracy?
Would it warp the cylinder?
It probably would need to be re-honed at the very least, but would it need to be bored out?
I know it would need more piston clearance than the rest of the bore so it doesn't stick when it heats up.
Anyone done it? Or even better, done it and have pictures and results?
Should I try it or am I just :bang:?
Thanks guys!
Is it possible to add an exhaust bridge to a cast iron cylinder with a single port? I've never done it.
Is it possible to weld anything in there with any accuracy?
Would it warp the cylinder?
It probably would need to be re-honed at the very least, but would it need to be bored out?
I know it would need more piston clearance than the rest of the bore so it doesn't stick when it heats up.
Anyone done it? Or even better, done it and have pictures and results?
Should I try it or am I just :bang:?
Thanks guys!