Manual oiler seals

[jerrycmorrow]

trying to replace seals on poulan 361 manual oiler. How to remove thumb button so can slide new o-ring on eithout breaking thumb button

 

[BJD85]

Its really easy. Take the saw and throw it in the trash
I couldent resist.

Sent from my LM-G710VM using Tapatalk

 

[BJD85]

My dad had one.

Sent from my LM-G710VM using Tapatalk

 

[s sidewall]

You talking about the red cap?
Never mind, was thinking oil pump.
Steve
Isn't this supposed to be in the Poulan thread, shame on you Jerry.

 

[jerrycmorrow]

Isn't this supposed to be in the Poulan thread, shame on you Jerry

True dat

 

[HarleyT]

How about some pics?

 

[HarleyT]

 

[jerrycmorrow]

Never mind. Figured it out.
Mounted the pump rod upside down in bench vise with the jaws holding the nut. Squirted some kroil where button snaps on to the rod. Adjusted small crescent wrench to diameter of the rod and placed it against the bottom of the button. Taking a SMALL hammer i GENTLY tapped on the wrench at the base if the button while firmly grasping the wrench handle being careful to strike it in alignment with the rod. Voila’ popped off. Project done