lovetheoutdoors
Addicted to ArboristSite
I dont know what there intentions were, i didnt notice it until i was back home with it. I have no experience with a mill but a 20" bar and a 70cc saw is a bit small right?
You can become a Supporting Member which comes with a decal or just click here to donate.
Says the guy who sold a minty Mastermind 272xp...
Its official... This thread had been hijacked!
3cc per 1'' of bar for me. 20 on a 70cc saw is a light saber. Not my place to say, but looking at your sig, Id unload the 441 or the 576 before Id let that mint 272p go. Both can easily be replaced, the 272 cannot. Also, with a ported 372xpw, and 2 ported 460s.... they don't bring anything to the table that those ported saws lack. The 272xp should be noticeably lighter than the 441 and 576. 272xp to me, was very Stihl like in performance. It's a rugged, dependable saw and was developed to compete with the Stihl 044. Given the choice between a 044, 272xp, and carb controlled 576xp and still 441..... Id pick the 044 or 272xp.
I'm curious, what are the four wholes in the bar for?
Chad, you have the nicest 272xp I have seen. I would not sell it. Sell something that, if you have remorse, you can go down to your local dealer and replace with one off the shelf.
Enter your email address to join: