What sort of lub is needed for the saw's gearcase after removing the transmission plug ? I found a reference that the amount is .18 pint, but I don't know what lub to use.
Also, there is an hole
in the housing at the rear of the saw ( see photo). The opening provides access to a threaded opening in the starter assembly cup. What is that design feature is for ? I wonder if I could be missing a part that goes there, or if this feature was created for use by someone repairing the starter assembly to get the fly wheel to spin. Any thoughts will be appreciated.
Also, there is an hole
in the housing at the rear of the saw ( see photo). The opening provides access to a threaded opening in the starter assembly cup. What is that design feature is for ? I wonder if I could be missing a part that goes there, or if this feature was created for use by someone repairing the starter assembly to get the fly wheel to spin. Any thoughts will be appreciated.
