Big Block
WFO or I don't go
How big in diameter can I mill with a 71cc saw? I know about running it a little rich and on 32:1 mix but what is max dia. that won't over work the saw It will also be ported soon too........
Is a sprocket nose preferable to a hard nose?
I mill with a 32 inch bar ,but use .404 chain ,with the .063 and .404 i do not need the extra oiler anymore ,when i ran .050 on a 28 3/8 the bar got real hot and needed the extra oiler .Hope this helps ,if you have a 3/8 tip on the 32 inch bar ,it can be swapped to .404 if decide to try it out .will need a different rim sprocket also .10 degrees on the chain top plate will give a nicer finish ,not as grabby ,keep your chain sharp and a ported 70cc should mill fine .I would most definitely be using an auxiliary oiler and have a properly sharpend chain.
I use a 28 sometimes with no trouble and also run 32:1 synthetic with minimal smoke...
Oy BobL, not to turn this in to an oilthread but you mean that it´s due to additives thet the oil does not smoke rather than esterbased lubes burn cleaner???
How big in diameter can I mill with a 71cc saw? I know about running it a little rich and on 32:1 mix but what is max dia. that won't over work the saw It will also be ported soon too........
Enter your email address to join: