morbius18
ArboristSite Operative
I took these off a MS441 that I converted to a mtronic one. I couldn't locate a mtronic flywheel with heater magnets. Was working when removed. I'm no longer building saws and this is the last parts that I have.
What you see is what you get.
Standard carb crankcase flywheel half.
Standard carb ignition coil.
Flywheel with heater magnets.
Generator coil with 2 screws.
Carb box (has a crack on the switch side)
Old steel muffler with gills.
1/2 wrap heated handle.
Carb heater plate.
Carb temp sensor.
Rear handle heater plate.
Heater switch and grommet.
Carb baffle plate with heater wire holder.
All wires and 2 extra shrink covers.
Standard carb assembly (pictured)
Asking $60 shipped.
What you see is what you get.
Standard carb crankcase flywheel half.
Standard carb ignition coil.
Flywheel with heater magnets.
Generator coil with 2 screws.
Carb box (has a crack on the switch side)
Old steel muffler with gills.
1/2 wrap heated handle.
Carb heater plate.
Carb temp sensor.
Rear handle heater plate.
Heater switch and grommet.
Carb baffle plate with heater wire holder.
All wires and 2 extra shrink covers.
Standard carb assembly (pictured)
Asking $60 shipped.