Finally was able to run a tank of fuel through my new MS441. Coming from a small Craftsman to this is a huge jump. I cut an old 24" pine stump down that was way to much for my old saw in approximately 30". Then cut three other 12" to 18" pines that were down into 2' sections. I thought the weight of the saw was going to be an issue but it actually made the cutting easier for me. Yes I am sure this is all old info but it is new to a :newbie:.
Here is my question..I ran a full tank through it and it only used less than half a tank of bar oil. Scary to me....my old craftsman was 1 to 1. Does this sound right...I never saw a lot of oil on the chain?
Here is my question..I ran a full tank through it and it only used less than half a tank of bar oil. Scary to me....my old craftsman was 1 to 1. Does this sound right...I never saw a lot of oil on the chain?