I had a 440 parts saw hanging around and needed a bigger saw. I therefore decided to rebuild my 440 with a 460 big bore P&C. I got plenty of info on how to do this brousing around previous theads. I added a modded muffler, full wrap bar...
I still have a few questions:
With this setup, can I run a 8 pin rim with a 24" bar?
I am still waiting for the parts (some are on backorder) but I am already worried about adjusting the carb. This is my first project and, although I've been using saws for years, I am still uneasy about adjusting the carb. Any advice? (I only have basic tools.)
Finally, my 440 has a basic (nylon?) mesh filter. With a bigger P&C, modded muffler and possibly some porting job, should I improve the air intake? How?
Thanks for your help and sorry for any spelling mistakes (I'm French)...
I still have a few questions:
With this setup, can I run a 8 pin rim with a 24" bar?
I am still waiting for the parts (some are on backorder) but I am already worried about adjusting the carb. This is my first project and, although I've been using saws for years, I am still uneasy about adjusting the carb. Any advice? (I only have basic tools.)
Finally, my 440 has a basic (nylon?) mesh filter. With a bigger P&C, modded muffler and possibly some porting job, should I improve the air intake? How?
Thanks for your help and sorry for any spelling mistakes (I'm French)...