Need driver count for cannon bar

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
zr900

zr900

ArboristSite Guru
Joined
Dec 27, 2007
Messages
629
Location
Southwest Michigan
Check Baileys woodland pro bar in the same configuration and it should be the same as the woodland pro bars are renamed cannons. Off the top of my head I am thinking 135

Just checked and the 42 Woodland pro and it was 136DL for 3/8
 
Last edited:
woodsrunner

woodsrunner

ArboristSite Operative
Joined
Mar 15, 2008
Messages
326
Location
florida
Mine is a Cannon Super Bar 42 inch and it takes 135 dl count chain. I bought it for my 076 and specifically wanted it to be 135 dl count because my Oregon Power match (large mount Husky)is 135 dl count. That way I can use the chains I already have.

So I would say 135.

Scott
 
Meadow Beaver
Joined
Jun 27, 2008
Messages
3,475
Location
Far from the landing
Mine is a Cannon Super Bar 42 inch and it takes 135 dl count chain. I bought it for my 076 and specifically wanted it to be 135 dl count because my Oregon Power match (large mount Husky)is 135 dl count. That way I can use the chains I already have.

So I would say 135.

Scott

That bar is a different mount and uses a different number of DL's. Besides if I had a large mount Stihl bar I would run that at 136 dl as well so I could run bigger sprockets on the bigger saws.
 
woodsrunner

woodsrunner

ArboristSite Operative
Joined
Mar 15, 2008
Messages
326
Location
florida
Yes, my bar is a 14 mm Stihl mount. Cannon's designation for that is S2. The Cannon large Husky mount is designated H1. All I'm saying is the Cannon site says its a 135 dl count. Both of those bars use a 135 dl count chain according to Cannon's website. I'm sure 136 would work fine. :)

Scott
 
Top