Opinions on a cylinder condition.

[3000 FPS]

I have this poulan 3450 I tore down because the piston was scored and there was transfer to the cylinder. I used the muractic acid which worked very well I might add and then sanded with 320. I noticed however that there are these small pits all over the inside of the bore. Also there is some areas of the cylinder on the intake side that have very small groves that I will not be able to get out. Would you try using this cylinder.
The small white specks on the exaust side you see are the pits in the cylinder.

 

[Dan Forsh]

The pits shouldn't be a problem, if you can't feel the grooves (catch a finger nail in them) then they shouldn't be either.

 

[3000 FPS]

The pits shouldn't be a problem, if you can't feel the grooves (catch a finger nail in them) then they shouldn't be either.

I can feel them with a fingernail but not real bad.

 

[Dan Forsh]

Your photo isn't the clearest, but if I see rightly, there are two lines just to the left of the port?

I would put a piston in it and run it, if it's your own machine.

 

[stevejr33]

if it was mine i would run it. might not be the best but will run good.

 

[3000 FPS]

Your photo isn't the clearest, but if I see rightly, there are two lines just to the left of the port?

I would put a piston in it and run it, if it's your own machine.

I could not get that close with the camera with out being out of focus but you still got it right. thanks for advice.

 

[3000 FPS]

Well so far the go with it have the majority.